How to clean a sewer in an apartment without a call plumber
Someone has a sewer can be hammered very rarely, and someone on the contrary - very often. In any case, clean the sewer, if it hammered, it will not be difficult. How to properly clean the sewer system yourself - we will tell further.
How to clean the sewer at home
How to clean the sewer in the bathroom
If you have a bad shower in the bathroom or in the sink and you do not know how to clean the sewage pipes, then try the old and simple method: boil the water in the pan and thengently( not to burn yourself with steam), pour it into the sink. If the blockage is not too complicated, then this should help.
As a rule, in drains of a shell and a bathroom the blockage occurs because of the accumulation of long hair. If the first method does not help, then help with the problem will help vantuz. In order to clean the sewer, drain some water into the drain, and then put the plunger in such a way that it closes the drain hole. Then open the water so that its level hides the rubber part of the plunger. Further slightly tilt the handle of the plunger and make some sharp jerks, applying to it efforts. Once you have made the last push - remove the plunger and let all the water drain down. Even if the blockage has disappeared, this procedure is recommended to be repeated 2-3 times.
Another way to clean the sewer - using a special tool to eliminate blockages in the sewer pipe.
Which means to clean the sewerage system
To date, there are quite a lot of tools that help to eliminate clogging in the sewer pipe. The most effective means, according to most customer feedback, is Tiret. Tiret will quickly eliminate blockage in any sewer pipe: in the kitchen, in the bathroom, in the toilet and in the riser.
How to clean the sewer in the kitchen
What is the best way to clean the sewer in the kitchen? Of course, the easiest way is to clean with boiling water, but this method is unlikely to help, although immediately it should not be ruled out. Then use the same methods that were mentioned above: cleaning with a plunger and using a special anti-block agent.
Other ways of cleaning the sewer
A more complicated process of cleaning sewage pipes - using a brush. In order to clean the sewer with a brush, you need to disassemble the siphon or pull out the perforated drain pipe going from the sink, from the sewer pipe. Then insert the rope wire into the pipe until it rests against the blockage, or it does not come to the end. After that, the handle is scrolled through the cable in the tube first quickly, then slowly, that is alternating movements.
How to clean the frozen sewage system of
If the sewage pipe is frozen, it will be almost impossible to clean it, in this case it is necessary to heat up the pipe. This can be done by pouring hot water( boiling water) into the sink, so the thin layer of ice that has formed must melt, then begin to pour out the water intensively to push the pieces of ice.
Another way to clean the sewer, if it is frozen, warming it. This method can be used exclusively for metal sewage pipes, for example, from cast iron. Heat the sewer pipe using a blowtorch. The duration of warm-up will depend on how deep the degree of its freezing is.