Rose Kanzashi from 5 cm ribbon: μ for bud making( with photo and video)

Kanzas appeared more than 400 years ago. Throughout this technique, this technique was transformed until it acquired the present appearance. Most often this technique is used to decorate the hairpin. Make flowers and attach to hair clips and bezels. Today we will make a rose, attention to the video-MK.

MK Rose kanzashi from tape 5 cm

To create a rose you need:

1. satin ribbon( width 5 cm);
2. lighter;
3. scissors;
4. pencil;
5. ruler;
6. adhesive.

To begin with, you need to cut the tape into squares of 5 centimeters. Immediately scorch the edges.

Such cubes should be 16 pieces.

Fold the square diagonally. You should have a triangle.

Wrap the corners inwards.

Cut a bit of the bottom.

Fill the edges. It should look like this.

Make all the other boxes as

Spread the glue on the back of the petal.

Take the middle.

Now glue this petal with other blanks.

So we got our little rose.

Master class rose bud Kanzashi

For such a bud you need: satin ribbon, needle, thread, scissors, lighter.

Cut the ribbon into squares.

h

Take one square and bend it diagonally.

Sew on the edge.

Slightly tighten, so that the ribbon is evenly spaced.

Then tighten to the end. A bud is formed.

Place the cloth as you want. Now make the second petal

So, continue until you are satisfied with the volume of the rose.

It is still possible when stitching petals, to turn them out. But this requires a longer ribbon.

Tighten and scorch the edges.

Make 19 of these petals.

Twist one petal into the bud.

Bind from below with thread.

Now paste the petals to the bud. But that the rose was beautiful first apply each leaf and choose the best place.

Here is our rose and ready.

Be sure to check out the training video master classes below.