Inoculation with a wedge

Vaccination with a wedge has also another name - gaufus vaccination. This method of grafting is used mainly when the diameter of the branch is large enough, and the cortex is thin, elastic, not thicker than 3-5 mm. This is a rather labor-intensive method of vaccination, requiring certain skills and training. For wedge grafting at the site of

Preparing the cuttings for grafting with the wedge

When grafting with a wedge, the two-sided cut is made in a two-sided cut so that both cut surfaces converge at the end of the wedge at an acute angle.

Technique for grafting wedge

1. should be made similar in shape to the wedge-shaped sections.

2. Place the graft in the cutout on the rootstock so that the slices coincide.

3 - Together with the joints of rootstocks and grafting, it is necessary to make a tight strap with a polyethylene tape, and the wounded fabrics should be covered with a garden vine.

the fork must be cut or cut down, and a wedge-shaped trihedral cut-out should be made from one side. On the cut should be made a wedge, in shape and size corresponding to the cut in the rootstock. Wedge wedge must be combined with the notch in the rootstock, inserting the wedge into the cutout. If the cutting is firmly held in the cutout, and the tissues of the stock of the rootstock and the grafting along the internal borders coincide, it means that the vaccination was successful and it is possible to carry out the strapping at the junction site. Wounds for root and priovo need to be covered with garden crockery or other insulating material in order to prevent infection from entering open unprotected wax and rootstock. A simpler and much more effective method of vaccination is the inoculation of the

with a wedge in the cleft, used only for the re-ingrowth of adult fruit trees. To do this, cut or cut the branch in the place of grafting and split the butt end with a garden knife, it should be done carefully, so as not to split in half and not to peel off part of the branch. To ensure that the gap does not close, it should be inserted into the peg or chip when preparing the cuttings.

Technique for carrying out an improved graft after the bark of

1. On the , the pre-cut cut must consistently perform two oblique cuts so that the

does not converge at the end at an acute angle.

2. On the stock you should make a cut of the crust 3-4 cm long and separate one edge of the bark from the

with a knife and slightly bend it.3 - Place the cuttings in the cut so that the additional cut on the cutter abuts the to the unthreaded edge of the stock bark. After installing the cuttings at the junction site, it is necessary to make the

strap. On the pruning cut, as in the case of grafting with a wedge, make 2 cuts from different sides so that their surfaces converge with a sharp wedge. The graft should be inserted into the cleft so that the bark and cambium of the graft match at least on one side with the bark and cambium of the stock. If the diameter of the branch is large enough to allow another stalk to be placed on the other side, it is necessary to do this. After the cuttings are inserted into the cleft, it is necessary to make a fixing bandage so that the cuttings are compressed by the walls of the cleft.