How to make pom-poms out of yarn, fur, paper or ordinary plastic bags at home( photo instructions)

Depending on the material from which the pompons are made, they can be used as a decoration for a hat, scarf and other clothes, ieas a winter accessory to warm clothes, for example, using paper pom-poms, you can decorate a room or make an accent in the interior. In this article, master classes with detailed instructions will be presented, thanks to which the needlewomen will understand how to make pompons from yarn and other materials.

Attention on the video

In this article a selection of videos will be presented, in which the masters will share the secrets of making such accessories. We will talk about several options for performing fluffy and paper pompoms.

From yarn

In order to make a voluminous, fluffy, soft pompon that can be attached to the hat as an ornament, synthetic, melange or woolen yarn, as well as a sheet of cardboard and scissors, will be needed.

First of all, it is necessary to decide what pompon of what diameter is planned to be performed, then it follows from the sheet of thick cardboard to cut two circles of the desired diameter, i.e. if the diameter of the planned pompon should be equal to fifteen centimeters, then the diameter of the two circles should also be equalfifteen centimeters. In the center of two circles, cut circles with a diameter of about three centimeters and make an incision, in order to make it more convenient to wind the yarn. You can not make a cut, then wind the thread with a needle.

Further it is necessary to put two prepared circles on each other and then it is possible to begin to tightly wrap threads with cardboard circles. When all the rows are completed, you need to cut the yarn threads in the middle with the help of scissors. Then thread, which is located between the circles of cardboard, it is necessary to tie in a knot. Then you need to remove the cardboard, trim the length of all threads, and the product is ready.

The pom-pon made of threads can be monochrome or multi-colored, it all depends on the chosen thread color.

We make a fur pom-pom.

In order to make a pompon made of fur, you will need: fur, filler, needle and thread, as well as scissors and tape. First it is necessary to lay out fur, then from it it is necessary to cut a fur circle, from the wrong side the workpiece should be sewed with large stitches. Then you need to prepare a small amount of filler and tie it with tape. After that, the prepared filler should be placed in the middle of the fur circle, and the tape should be placed outside. Then you need to tighten the circle and tie the knot. The tape is needed to sew or tie a pompom.

From paper

In order to create a holiday atmosphere or simply decorate the interior, you can perform pompons made of paper. For work best suited is crepe or thin wrapping paper, thin wire or thread, scissors. First you need to cut the paper into sheets twenty-centimeters wide, thirty centimeters long. Eight sheets of paper are required for the production of each pompon. Eight sheets of paper should be placed on top of each other, then fold the sheets followed by an accordion, so that the width of the fold was one and a half centimeters. After this, the workpiece must be bent in half, and the bend should be tied with wire or thread, then the edges of the workpiece should be cut off from both sides. Next, you need to carefully spread out all the layers of paper and the product is ready.

From

packages It's easy and simple to perform pompons with your own hands from regular packages. For work, you will need bags, scissors and scotch tape.

First you need to prepare the packages, stack them with a stack, combining all the sides. In order for the pompons of the packages to turn out to be bright, you need to stack the packages in a stack, alternating colors. After the bags have been stacked, cut off all sharp corners and cut the bags in places of adhesion. Then the stack should be folded in half and cut in the middle with scissors. Then on both sides you need to make cuts, the main thing is that the strips are the same. Next, the stack should be bent again, then twisted and fixed with an adhesive tape, and everything is ready.