Video lessons of Kansas for beginners: rims and hair clips with your own hands
Video lessons of Kanzashi for beginners with their own hands + a step-by-step master class with a photo
About 400 years ago in Japan there was such kind of needlework as kanzashi. On the studs and crests were attached decorations from ribbons and beads. With such ornaments, it was easy to determine the status of a girl. Many believed that if you wear such amulets, they will drive away evil spirits. Video lessons "Kanzashi for beginners" will help quickly learn this kind of needlework.
Step-by-step MK to decorate the rim of Kanzash
To decorate the bezel you will need:
- tweezers;
- scissors;
- ruler;
- file;
- thread;
- needle;
- pencil;
- lighter or candle;
- adhesive;
- two satin ribbons;
- bezel;
- rhinestone or bead.
To begin with, scorch thin ribbons.
Inside the tapes, drip glue.
Make a loop.
You should have two loops.
Turn the ribbons face to face and thread the green ribbon through the yellow ribbon.
Next, flip the yellow ribbon over the index finger of your left hand.
This is necessary to put it in the green.
In the resulting yellow loop.
Insert the green tape.
Pull the yellow ribbon slightly.
Next, repeat this action and you will have a pigtail.
Do not cut the tapes yet. Take the bezel and clean the bezel and give a rough surface to the rim.
Now on the bezel, apply glue.
Glue the pigtail to the rim on the entire surface.
Now trim the edges of the tape.
Searches.
And glue to the inside of the rim.
For the flower, you need to take a wide ribbon, measure five centimeters and cut it off. Such squares should be 8 pieces.
The edges need to scorch.
Take one square and fold it diagonally, inside out.
The resulting triangle fold in half.
Now fold the triangle again to make a petal.
Then cut the tip of the petal.
Should have a petal.
Make 8 more petals.
Now you need to connect all the petals.
You should get this kind of flower.
Spread the glue inside out the flower and glue it to the rim.
Glue the bead to the center of the flower.
Make the flower unusual, you can paste the decoration in the form of a ladybug.
So your exclusive bezel is ready.
Links to video Kanzashi
This flower can be attached not only to the rim, it will look good on the hairpin or scallop. Here are a few links to video lessons of Kanzash with their own hands.
Many people think that Kanzash is a very complicated kind of needlework. But do not be afraid to try, everything is simple.
About 400 years ago in Japan there was such a kind of needlework as Kanzas. On the studs and crests were attached decorations from ribbons and beads. With such ornaments, it was easy to determine the status of a girl. Many believed that if you wear such amulets, they will drive away evil spirits. Video lessons "Kanzashi for beginners" will help quickly learn this kind of needlework.
Step-by-step MK to decorate the rim of Kanzash
To decorate the rim you will need:
- tweezers;
- scissors;
- ruler;
- file;
- thread;
- needle;
- pencil;
- lighter or candle;
- glue;
- two satin ribbons;
- bezel;
- rhinestone or bead.
To begin with, scorch thin ribbons.
Tap the adhesive inside the tapes.
Make a loop.
You should have two loops.
Turn the ribbons face to face and thread the green ribbon through the yellow ribbon.
Next, flip the yellow ribbon through the index finger of the left hand.
It is necessary to put it in green.
In the resulting yellow loop.
Insert the green ribbon.
Tighten the yellow tape slightly.
Next, repeat this action and you will have a pigtail.
Do not cut the tapes yet. Take the bezel and clean the bezel and give a rough surface to the rim.
Now on the bezel, apply glue.
Glue the pigtail to the rim on the entire surface.
Now trim the edges of the tape.
Searches.
And glue to the inside of the rim.
For the flower, you need to take a wide ribbon, measure five centimeters and cut it off. Such squares should be 8 pieces.
Edges need to scorch.
Take one square and fold it diagonally, inside out.
The resulting triangle fold in half.
Now fold the triangle again to make a petal.
Then cut the tip of the petal.
Should have a petal.
Make 8 more petals.
Now you need to connect all the petals.
Should be like this flower.
Spread the glue inside out the flower and glue it to the rim.
Glue the bead to the center of the flower.
Make the flower unusual, you can paste the decoration in the form of a ladybug.
So your exclusive bezel is ready.
Links to video Kanzashi
This flower can be attached not only to the rim, it will look good on the hairpin or scallop. Here are a few links to video lessons of Kanzash with their own hands.
Many people think that Kanzash is a very complicated kind of needlework. But do not be afraid to try, everything is simple.