The technique of ayris folding: patterns and templates for the manufacture of hand-made articles

The technique of ayris folding is the creation of a drawing using multi-colored strips of paper arranged in a spiral. The location may be chaotic or have a certain sequence. Also it is necessary to use schemes and templates, we'll talk about them below.

Prepare a template

1) To create a template, you need to choose a geometric figure suitable for your design, in the form of a square, triangle, rectangle or polyhedron. For this picture you need to take a square whose side is 14 cm. For convenience, the sheet is used in a cage. On each side of the square, postpone a step of 15 mm in size.

2) Connect the points obtained by straight lines.

3) In the large square, another square of a slightly smaller size was obtained. In it, also on each side, set aside 15 mm and connect the dots. In the new resulting square again postpone the width of the step and so on until you get a very small box inside. Thus, a template is prepared.

For ayris folding, special paper is used, but if it is not, the usual color, packaging, pages of an old glossy magazine can come up. Pictures of corrugated or velvet paper will be more attractive. Depending on the imagination, you can use other materials, for example, fabric.

Technology at first glance may seem complicated, but in fact it is not. How the process takes place can be understood by looking at the master class on ayris folding for children.

A step-by-step master class in this

technique A spiraling pattern will be obtained thanks to the paper strips folded in half, so that they close the figured slot. Strips should have a certain width, superimposed clockwise at a certain angle. Sometimes it is enough to use one or two colors of paper, but to get a more beautiful original drawing, it is better to use the 5th or 6th colors. In this case, an example is the one-ton duck model.

To perform the work, you will need:

1) Schematic diagram. A ready template can be printed from the Internet or drawn by yourself. The indicated numbers on the bars indicate in which order they need to be laid out.

2) Paper strips that need to be bent in half. For a more even bend, you can first hold in its place a nail file. To understand the width of the strip, you need to measure it on the diagram and add 3 - 4 mm.

Then cut out all the strips at once or as they are folded.

3) Copy paper for transferring a drawing onto a sheet of cardboard. And scissors to make a figured slot. Scheme overlay on the wrong side of the cardboard.

4) Clips for securing the circuit on a base. Cutting the pattern along the contour, you need to fold the front side of the base from the front side of the diagram.

5) Adhesive tape for securing strips on the basis. When using glue-pencil instead of tape, make sure that it was applied only to the contour, since the picture can be glued to the circuit. Strips with numbers corresponding to the numbers on the diagram are applied and fixed with adhesive tape or glue. It is important that the folding line of the strips coincides with the lines on the diagram.

Next, you need to do:

1) The cut-out slot is completely filled with strips. As a result, the remaining figure in the center of the pattern should be covered with a rectangle of paper of a different color.

2) Turn over the work and remove the circuit.

3) In the end, decorate the resulting picture with applique and decorative details.

This lesson presents the technique of ayris folding for beginners, it will help develop aesthetic taste, nurture accuracy and patience, teach you how to work according to the plan.

Related videos of the article:

.